| Част Не | Производител | Заявление |
|---|
| MAX6312UK36D2-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output, factory-set reset threshold on Vcc, 1 additional undervoltage reset input, manual-reset input). Factory-trimmed reset thresholds 3.510(min) 3.690(max). Nominal timeout period 20ms. |
| MAX739CPD | MaximIC | -5V, inverting carrent-mode PWM regulator. |
| MAX535AEUA | MaximIC | Low-power, 13-bit voltage-output DAC with serial interface. INL (LSB) +-1/2. +5V single-supply operation. |
| DG528CK | MaximIC | 8-channel latchable multiplexer |
| MAX543BCWE | MaximIC | CMOS, 12-bit, serial-input multiplying DAC. Linearity (LSB) +-1 |
| MAX4274BFEUA | MaximIC | Dual, Rail-to-Rail, GainAmp op amp with precision internal gain-setting resistors. Rf/Rg inverting gain 25, 1+ (Rf/Dg) noninverting gain 26, -3dB BW 580kHz. |
| MAX399EJE | MaximIC | Precision, dual 4-channel, low-voltage, CMOS analo0g multiplexer. |
| MAX6711REXS-T | MaximIC | Microprocessor reset circuit with manual reset input. Reset threshold 2.63V. Output type active-low push-pull reset. |
| MAX6358LTUT-T | MaximIC | Dual-voltage microprocessor supervisory circuit with manual reset. Reset threshold 4.63V (Vcc5) and 3.08V (Vcc3). Active-low open-drain reset. Watchdog timer. |
| MAX6322HPUK34B-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.400V, reset timeout(min) 20ms |
| MAX6316MUK38CY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 3.800V, min reset timeout 140ms, typ watchdog timeout 1.6sec |
| MAX6309UK45D3-T | MaximIC | Multiple-input, programmable reset IC (push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,manual-reset input).Factory-trimmed reset thresholds 4.388(min),4.613(max) Nominal timeout period 140ms. |
| DG305CK | MaximIC | CMOS dual and quad analog switch. |
| MAX6317HUK29AZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 2.930V, min reset timeout 1ms, typ watchdog timeout 25.6sec |
| MAX6319LHUK49A-T | MaximIC | Microprocessor supervisory circuit with manual reset (manual reset input, reset outputs active-low,push/pull and active-high, push/pull).Factory-trimmed reset threshold(typ) 4.900V, reset timeout(min) 1ms |
| MAX232CSE | MaximIC | +5V-powered, multichannel RS-232 driver-receiver. |
| MAX6327UR28-T | MaximIC | Ultra-low-power microprocessor supervisory circuit (reset output active-high, push-pull). Reset threshold (typ) 2.800V. Order increment 10k |
| MAX263BCPI | MaximIC | Pin programmable univesal and bandpass filter. Accuracy 2%. |
| MAX6102EUR-T | MaximIC | Low-cost, micropower, low-dropout, high-output-current, SOT23 voltage reference. Output voltage 2.500V, input voltage range (Vout + 200mV)V to 12.6V to 12.6V. |
| MX7503KN | MaximIC | Low-power, monolithic, CMOS analog multiplexer. |
| MAX779LMJA | MaximIC | Low-voltage input, step-up DC-DC converter |
| MAX6377XR31-T | MaximIC | Ultra-low-power voltage detector, 3.1V |
| MAX6318LHUK29BZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 2.930V min, reset timeout 20ms, typ watchdog timeout 25.6sec |
| MAX713CSE | MaximIC | NiCd/NiMH battery fast-charge controller (negative voltage-slope detection scheme). |
| MAX6318LHUK37DX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 3.700V min, reset timeout 1.12sec,typ watchdog timeout 102ms |
| MAX6318LHUK41CY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset,(watchdog input,reset output active-low,push/pull; active-high,push/pull).Factory-trimmed reset threshold(typ) 4.100V min, reset timeout 140ms,typ watchdog timeout 1.6sec |
| MAX6364LUT23-T | MaximIC | Low-power microprocessor supervisory circuit with auxiliary adjustable reset input. Reset threshold(typ) 2.32V. Active-low push-pull reset. |
| MAX6316MUK40DZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 4.000V, min reset timeout 1120ms, typ watchdog timeout 25.6sec |
| MAX886ECJ | MaximIC | Wireless and satellite handset power-management IC. Hiher preset voltage range. |
| MAX4168EPD | MaximIC | Dual, high-output-drive, precision, low-power, single-supply +2.7V to +6.5V, Rail-to-Rail I/O op amp with swhutdown. |
